Carrier KGANP5201VSP Manuel d'instructions télécharger pdf (Page 3)

HOTSURFACE

IGNITER MANUALRESET

GASBURNER i ROLLOUT SWITCH

i /

ELECTRICALJUNCTION

BOX(

REPRESENTATIVE DRAWING ONLY, SOME MODELS MAY VARY IN APPEARANCE

Fig. 1 - Component Location

Al1408

MANIFOLD/ORIFICE/BURNER REMOVAL

UNIT OPERATION HAZARD

Failure to follow this caution may result in unit damage or

improper operation.

Label all wires prior to disconnection when servicing

controls.

D'EQUIPEMENT D'OPERATION

Toute erreur de cfiblage peut _tre une source de danger et de

panne.

Lors des op6rations d'entretien des commandes, 6tiqueter

tous les ills avant de les d6connecter.

3. Support the manifold and remove the 4 screws that secure

the manifold assembly to the burner box and set aside.

4. Note the location of the green/yellow wire ground wire for

re-assembly later.

5. Slide one-piece burner assembly out of slots on sides of

burner box.

6. Remove the flame sensor from the burner assembly.

7. Remove the orifices from the manifold and discard.

Orifice

Connect Green/Yellow

ground wire here

Gas Valve

Manifold

NOTE: Use a back-up wrench on the gas valve to prevent the

valve from rotating on the manifold or damaging the mounting to

the burner box.

1. Disconnect the gas pipe from gas valve and remove pipe

from the furnace casing.

2. Disconnect the connector harness from gas valve. Discon-

nect wires from Hot Surface Igniter (HSI) and Flame

Sensor.

Gas valve is parallel to manifold " /

CLwithin + or - 3_ ,/' /"

/'_ I>/- ,"

Gas valve must be installed on

manifold with minimum engagement of

6 threads. Cross threading is not

acceptable.

• Indicated surfaces

to be 90 _+ or -2 _

A11486

Fig. 2 - Modulating Gas Valve with Orifices

1 2 3 4 5 6 7 8 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Carrier KGANP5201VSP Manuel d'instructions Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Chauffe-eau et chaudières Carrier KGANP5201VSP