Carrier 38TXA Guide Guide de l'utilisateur télécharger pdf (Page 46)

46 Chapter 2

S:\agilent\83217\OPT001\BOOK\CHAPTERS\tdscrip.fm

Test Descriptions

TEST_18 - RXA SINAD

Parameters Used

High and low supply voltages are measured only if an external power

supply has been configured to be used over GPIB by the test system and

if parameter 20. RT Test at Extreme Settings [0=no 1=yes] is set 1. See

“TEST_13 - TXA Current Drain” on page 36 for details on configuring

an GPIB power supply.

• 1. CPA Control Channel [1-799 or 991 -1023]

• 2. CPA DSAT Vector

• 3. CPA Enter Ph# [0=If Needed,1=Always,Here]

• 4. CPA MIN From? [0=RECC,1=All 0’s,2=Phone #]

• 5. CPA Prt RECC RVC Data [0=no 1=yes 2=fail]

• 6. CPA SAT Tone (Hz)

• 14. RC Compandor is Always On [0=no 1=yes]

• 15. RT High Supply Voltage (Vdc)

• 16. RT Low Supply Voltage (Vdc)

• 17. RT Nominal Supply Voltage (Vdc)

• 20. RT Test at Extreme Settings [0=no 1=yes]

• 22. RX RF Level for Signaling (dBm)

• 27. RXA NAMPS RF Level for SINAD (dBm)

• 28. RXA NAMPS RF Level for SINAD at Extremes (dBm)

• 29. RXA RF Level for SINAD (dBm)

• 30. RXA RF Level for SINAD at Extremes (dBm)

• 31. RXA Set Audio Lvl [0=no xx=level volts]

• 32. RXA Tolerance for Setting Audio Level (% error)

• 49. TXA TS Atten for Signaling [0, 20, 40] (dB)

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 213 214

Pas de commentaire

Carrier 38TXA Guide Guide de l'utilisateur Page 46