Carrier Edge TP-PHP Manuel d'instructions télécharger pdf (Page 23)

A07219

Fig. 15 -- Equipment Control Module

5. Match and connect equipment wires to proper terminals of each connector

block.

6. Push any excess wire into wall and against Equipment Control Module. Seal

hole in wall to prevent air leaks. Leaks can affect operation and cause incor-

rect temperature measurement.

7. Remove 2--wire pigtail from thermostat mounting base and attach to Equip-

ment Control Module terminal block (terminals V+ and Vg). Attach 2--wire

pigtail to the back of the Display Module via 2 pin, keyed connector.

8. Reattach Display Module body to Equipment Control Module by first set-

ting on at top and then push bottom corners to snap into place. See Fig. 16.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 67 68

Pas de commentaire

Carrier Edge TP-PHP Manuel d'instructions Page 23