Carrier PERFORMANCETSERIES EDGER THERMIDISTATT CONTROL TP-NRH-A Manuel d'instructions télécharger pdf (Page 15)

6. Match and connect equipment wires to proper terminals of each connector

block, being careful not to over tighten the screws. Correct polarity must

be observed when connecting the two wires from the Equipment Control

Module to the Thermidistat Control mounting base. If wires are con-

nected incorrectly, the Display Module will not operate. See Fig. 7, 8 and

A08072

Fig. 7 -- Control Module Wiring Guide

S Red is V+

S Black is Vg

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 83 84

Pas de commentaire

Carrier PERFORMANCETSERIES EDGER THERMIDISTATT CONTROL TP-NRH-A Manuel d'instructions Page 15