Carrier PERFORMANCETSERIES EDGER THERMIDISTATT CONTROL TP-NRH-A Manuel d'instructions télécharger pdf (Page 14)

2. Route wires through large hole in mounting base. Level mounting base

against wall (for aesthetic value only—Display Module need not be lev-

eled for proper operation) and mark wall through 2 mounting holes. See

Fig. 6.

A07165

Fig. 6 -- Backplate Mounting

3. Drill two 3/16 --in. mounting holes in wall where marked. Thermidistat

Control may be mounted to a standard junction box, if desired. Hole pat-

tern on Thermidistat Control mounting base matches junction box mount-

ing holes.

4. Secure rear plastic mounting base to wall with 2 screws and anchors pro-

vided. Additional mounting holes are available for more secure mounting

if needed. Make sure all wires extend through hole in mounting base.

5. Adjust length and routing of each wire to reach proper connector block

and terminal on mounting base with 1/4--in. extra wire.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 83 84

Pas de commentaire

Carrier PERFORMANCETSERIES EDGER THERMIDISTATT CONTROL TP-NRH-A Manuel d'instructions Page 14