Carrier TP-NHP Manuel d'utilisateur télécharger pdf (Page 12)

Two−Piece Installation

The following steps should be followed for the installation of the two−piece

configuration.

NOTE: The 2−wire pigtail is not intended to support the weight of the User

Interface. Do not hang the User Interface from the equipment Control Module

screw terminals.

1. Remove mounting plate from back of Display Module by pressing the

two tabs on the bottom edge and pulling away. See Fig. 4 and 5.

A07225

Fig. 4 − Press Tabs to Remove Backplate

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

Pas de commentaire

Carrier TP-NHP Manuel d'utilisateur Page 12