Carrier operating and maintanance Manuel de l'opérateur télécharger pdf (Page 30)

Rev. __________

Date _________

2.12

4. Set the grid width as required for

the vehicle to be towed. Be sure

both grids are as close to the

center of the boom as possible.

5. To set the grid width, loosen the

“T” handles on the front of the

grid arms and pull the grids out.

Be sure both grids are as close

to the center of the boom as pos-

sible, and wide enough to allow

the “L” arms to slide into their

channels. Tighten the “T”

handles to secure the grids.

6. Retract the “Cam” handle lock-

ing pin on the grid by turning it a

half turn. It should remain in the

open position.

7. Extend the lift arm under the ve-

hicle being sure that all under

carriage parts are cleared and

that the front portion of the grid

is in contact with both tires.

Lower the grid fully to the

ground. There is no reason for

the operator to get under the

vehicle.

8. Visually inspect the tire to grid

contact before proceeding.

9. Take the “L” arms and slide them

into the channels on the side of

the grid. Insure that they are

resting snugly against the tires,

with the “L” arms in close con-

tact with the tires, reset the lock-

ing pin by turning the “Cam”

handle back to the original posi-

tion. Be sure that the pin seats

in one of the holes. The tires

are now confined front and back.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 43 44

Pas de commentaire

Carrier operating and maintanance Manuel de l'opérateur Page 30