Carrier operating and maintanance Instructions d'exploitation télécharger pdf (Page 8)

4. LIFTING INSTRUCTIONS

4.1. General

There are transport and lifting instructions attached

to the AHU.

4.2. Lifting Bar Certification

The lifting bars supplied are for single use and certi-

fied in accordance with Machinery Directive 2006/42/

EC, annex II-A. Selection.

4.3. Fastening of the Lifting Bars

• Remove the bolt and the locking plate on one side

of the lifting pipe.

Figure 5. Fastening the lifting bars - 1

• Slide the lifting bar into the hole in the subframe

intended for that purpose.

3. PREPARATION for ASSEMBLY

The following material is supplied as standard by

Alarko Carrier:

• Installation, maintenance and operating instruc-

tions

• Installation, operation and maintenance manual

• II A declaration

• Connecting parts

• Material list

The following material is supplied as an option by

Alarko Carrier:

• Anti-vibration mats

• Outside air suction grille

• Heat recovery wheel control

• Steam generator and accessories

Check that all necessary parts are supplied with the

AHU.

Measure the location and make sure it is tidy. The

floor of the installation area should be level and flat

to avoid connection problems. Any uneven surfaces

should be evened out with infill plates.

Determine the correct assembly sequence of the

AHU sections. Use the most logical sequence, tak-

ing the location into account. Begin with the casing

section that must be positioned on the highest part

of the floor, so that the other casing sections can be

added around it.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 40 41

Pas de commentaire

Carrier operating and maintanance Instructions d'exploitation Page 8